📱 🔀
Please rotate your device
This configuration tool requires landscape mode for the best drag-and-drop experience.
ICDM-RX/MOD Setup Configurator
Controllers
Modbus/TCP Master
Modbus/TCP Slave
Ethernet TCP/IP Master
Modbus RTU/ASCII Master
Modbus RTU/ASCII Slave
Modbus over Ethernet TCP/IP Master
Modbus/TCP Master/Slave
Raw/ASCII over Ethernet TCP/IP
Build Your Setup
Drop First Device Here
Drop Second Device Here
Masters are on different Ethernet subnets
One Master to Multiple Masters
Enable Private Serial Bus
Contains both a Modbus master and one or more Modbus slaves on the same serial bus.
Allows only the Modbus master the ability to communicate directly to the Modbus slaves.
May provide access from the Modbus master to public Modbus network(s) via an advanced gateway, such as the ICDM-RX/MOD running Modbus Router firmware.
Devices are remotely located over Ethernet
Enable Read Only Modbus Protection
Blocks all standard Modbus write messages from being transmitted out a serial port.
Allows monitoring systems to retrieve data while preventing unauthorized or errant changes.
Standard per-port Read-Only configuration (Section 5.1)
RO & RW support over Dual Serial Port Device (Section 5.2.2)
RO & RW support over Serial + Ethernet Device (Section 5.2.3)
Resolve Modbus Device ID Conflicts (Section 6.5)
Uses Alias Device ID and Device ID Offset to solve routing issues.
Effectively reassigns IDs without modifying controller logic or slave configurations.
Modbus/TCP Master to Local Devices (Section 6.5.1)
Serial Master to Local & Remote Devices (Section 6.5.2)
Serial Master to Two Remote Raw/ASCII Devices (Section 6.5.3)
Merging Two Serial Modbus Networks (Section 6.5.4)
Modbus Connectivity between Separate Ethernet Networks (Section 6.5.5)
Reset Setup
Configuration Required:
Recommended Firmware:
Alternate Firmware:
Manual Reference:
Alternate Firmware:
Alternate Reference:
Devices
Modbus/RTU
Modbus/ASCII
Serial Raw/ASCII
Ethernet TCP/IP Raw/ASCII